Workforce communication for employees and supervisors. Since 2008.

Safety Communication

What a Safety Orientation Video Can and Cannot Do

A safety orientation video can introduce your safety expectations and each employee's responsibilities the same way every time, in the workplace where the work is done. It does not replace required training, hands-on instruction, regulatory guidance or the judgment of qualified safety professionals. Those professionals decide what training is required, and the video supports the program they run.

Where a safety orientation video fits

New employees hear about safety from whoever runs orientation that day. The message can vary with the facilitator, the shift, the location and how much time is left in the session.

A video gives every new employee the same introduction. Depending on what your safety professionals approve, it can state the company's safety expectations, explain what each employee is responsible for, show how to report a hazard, an injury or a near miss, and tell employees where to go with a question.

It is an introduction. It tells a new employee what the company expects and where the rest of the safety program begins.

For an employer with more than one site or shift, the same core message can be shown everywhere, with sections that differ where the work differs. See keeping orientation consistent across locations and shifts.

Showing the actual workplace

A purchased safety video shows someone else's building, equipment and people. A custom one can show yours.

That means the entrance employees use, the aisles and walkways, the protective equipment issued at your site, the signs on your walls and the terms your supervisors use. A new employee sees the dock, the production line or the patient floor on screen before walking onto it.

It also means everything on camera has to be right. The video will show whatever was filmed, so the people who know the approved procedures need to review what appears on screen as well as what is said.

In short

  • A safety orientation video introduces expectations and responsibilities the same way to every new employee.
  • It can show your workplace, your equipment and your reporting steps.
  • It does not replace required training, hands-on instruction, regulatory guidance or qualified safety professionals.
  • Your safety professionals decide what training is required and approve what the video says and shows.
  • Review the video when equipment or procedures change.

What it does not replace

A video cannot watch an employee perform a task. It cannot answer a question, correct a mistake or confirm that a person is ready to do the work. Those things take an instructor, a supervisor and practice with the real equipment.

Required training. Your qualified safety professionals decide what training is required for each job, who receives it and how it is delivered. A safety orientation video does not stand in for any of it.

Hands-on instruction. Seeing a task on screen is different from doing it under the eye of someone qualified to teach it.

Regulatory guidance and professional judgment. A video is not a source of regulatory guidance. Whether any part of a video has a place in required training is a decision for your qualified safety professionals, not for the producer.

First Cut's safety communication work supports an employer's existing safety program. It does not replace required training, regulatory guidance or qualified safety professionals.

Describe the video accurately inside the company as well. Call it what it is, an orientation to safety expectations. If it is described as training, a supervisor may assume instruction has taken place that has not.

After orientation: supervisors and updates

What a new employee sees on the first day is repeated, or not, by the supervisor on the floor. A short discussion guide or a set of talking points gives supervisors the same approved expectations to reinforce, in the words the video used. It also tells them where to send an employee whose question they cannot answer.

A safety video has to stay current. When equipment is replaced, a procedure is revised or a reporting step changes, the people responsible for the safety program should review the video against the change.

A program built in sections lets the affected part be replaced without remaking the rest. A short refresher about the change can be shown to current employees as well as new ones.

What to settle with your safety lead before production

Agree on these points before a script is written:

  • which topics the video introduces, and which are left to required training and hands-on instruction
  • who approves the script, and who reviews the footage for what it shows
  • what instruction follows the video, and who delivers it
  • how employees ask questions, and who answers them
  • how the video will be described to employees and supervisors
  • who is told when equipment or procedures change, so the video is reviewed

The answers shape the script. They also keep the video in its place as one part of a program your safety professionals direct.

Questions employers ask

Can we use a purchased safety video instead of a custom one?

That is a question for your safety professionals, who decide what each program is used for. In practical terms, a purchased video covers a general topic and shows a generic workplace. A custom video states your expectations and shows your site. The two can be used together.

Should safety be its own video or part of the general orientation?

Either can work. A separate safety module is easier to replace when procedures change and easier to show again on its own. A safety section inside the main program keeps safety beside the company's other expectations on the first day. A program can do both, with a brief statement in the core video and a fuller module after it.

What should we watch for when filming in the workplace?

Everything on camera becomes part of the message. Have a safety professional present during filming and again in the review, so the protective equipment, the guarding and the way each task is performed match your approved procedures. A shot that shows a shortcut should be cut or filmed again.

Tell Us What Needs to Be Communicated

Tell us what you are using today, what your safety team wants new employees to hear, and who needs the information.